Mini F3 Flight Controller with OSD – Betaflight – DSHOT – (20x20mm mount)

Purchase this product now and earn 22 Points!

USD $22.99

Mini F3 high quality OMNIBUS compatible little flight controller which can reliably run on 2-4S batteries and integrates OSD and signals connector for Tiny 10A 4 in 1 Cicada ESC and DSHOT support for ultimate performance.

MPU6000 gyro will provide stable locked-in flight performance.

Out of stock

StumbleUpon

Earn 100 points for reviewing this product

SKU: 4301 Category: Tag:

Description

Wiring diagrams

Generic wiring diagram


F3 MINI BEC-OSD Wiring Diagram

Wiring 3.3V receiver to FC


Wiring spektrum satellite receiver

Firmware

Flight controller uses OMNIBUS betaflight firmware.

Firmware with native support for spektrum binding

If you are unable to bind spektrum receiver via betaflight, then please flash the following firmware which properly implements support for binding:
betaflight_3.1.7 with support for binding spektrum satellite receiver

Reviews

  1. cvincross

    Here are the pads that you have to bridge to put this board into DFU bootloader mode – in case something goes wrong flashing new firmware and you happen to brick it. Bridging these pads will enable you to upload new firmware. unbridge them to use the board again.

  2. Lukas (verified owner)

    For how much amps is the 5V out rated? I want to power the tx03 AIO cam directly from the board.
    Thank you

    • dmitry

      It is rated 1Amp and you should be able to power tx03 without issues, but one thing to keep in mind that Pololu 1A is far more superior than built-in BECs

  3. willwill56

    Do M3 nylon screws fit into the mounting holes fairly well? I’ve been looking for a 20×20 flight controller with OSD and M3 mounting holes (and 4-in-1 ESC micro connector is good too).

    • dmitry

      Yes, it has M3 mounting holes

Add a review