FlexRC Pico Core is very easy to assemble, just follow the steps before and your racing drone will be ready in just a few minutes.
Solder battery connector to ESC
Cut off red and black wires
Result will look like this:
Solder black and red wires to power pads
Install nylon hardware
If hardware does not fit well, then use silicone washers to prevent damage to components. You can also slightly shave off excessive material from nylon standoffs which prevents them from fitting well.
Solder power wires (+) and (-) to Fliught Controler
Install Flight Controller on Nylon Standoffs
Solder signal wires to Flight Controller
3 thoughts on “How to assemble FlexRC Pico Core DIY Kit”
why do you solder +ve & -ve from battery wires to FC? dosnt it run off 5v?
FC has built-in BEC and should be powered directly from the battery power
Thank you for wiring diagram. You can not believe how hard it was to find this information. Love the 4 in 1 bored but they sure do not include much information for moons. Lol